Install the drip edge by fitting it on the roof eave pushing it tightly against the edge of the plywood and.
Roof drip edge installation after shingles.
Place the metal roof drip edge flashing along the gable ends.
Slide the corner tight to the fascia.
Be sure to tuck the drip edge under the starter strip and felt paper.
If it doesn t pull the drip edge out slightly from under the shingles.
Place a nail at one end then the other.
Using drip edge with a nailing edge approx.
You may need to nail through the starter strip into the drip edge.
4 deep nail the drip edge to the sheathing every 16 if installing multiple runs of drip edge lap them by 1 4 1 2 inch keeping the nail back from the lapped joint.
Slowly lift a shingle that is closest to the apex of the roof.
Make sure the corner is tight and that the bottom edge is tight to the fascia before nailing off the drip edge.
Measure the length of the eave you need to cover with drip edge using a tape measure.
Slip the wide flat flange of the material all the way under the first course of roof shingles as illustrated.
This will allow for expansion and contraction and prevent buckling.
Secure the drip edge with roofing cement.
Push the drip edge a bit so that it passes under the shingle and appears from its other side.
Select enough lengths of.
Install the starter course.
Use a flat pry bar and hammer to pry the nails out of the drip edge gently.
Drip edging is a strip of flashing that is applied to the edge of roofing prior to the installation of other items.
Save yourself some.
Gently lift up the shingles on the edge of the roof and locate the nails holding the existing drip edge onto.
How to fix a roof drip edge installing roof drip edge flashing properly.
How to install drip edge flashing on a roof step 1.
Make sure the outer edge extends over the gutter.
Apply a continuous bead of cement along the top of the drip edge then press down on the shingle.
Install roof drip edge along the eaves add underlayment then place drip.
Once free slide the drip edge out and discard.
It can be done.
The starter course is comprised.
It is designed to protect the roof s sheathing from water damage caused by rain snow or ice being blown or rolling back beneath the edge of the shingles.
How to install a drip edge.
The way your sheeting is on top of the sub facia requires a drip edge to cover it so that the edge of the sheeting doesn t wick moisture into it.
Make sure to support the long end of the cut if you let it fall after cutting it will bend down and kink the drip edge.
Now that the roof is applied it is much more difficult invasive time consuming to install the drip edge being 3 stories only makes it much worse.
Using a utility knife cut back the front end of the drip edge.
