Make sure the outer edge extends over the gutter.
Roofing gutter drip edge installation.
Slide the corner tight to the fascia.
Raise the shingles and push the top rim of your drip edge beneath them.
Some rain runoff by capillary action runs up under the shingle drip edge and down the fascia behind the gutter installing drip edge on a new roof or re roofing job.
You can use nails to tightly secure it.
With without rain gutters.
Use a flat pry bar and hammer to pry the nails out of the drip edge gently.
Make sure the corner is tight and that the bottom edge is tight to the fascia before nailing off the drip edge.
How to install a drip edge.
For drip edge installation align it for directing water flow into gutter alongside the roof edges.
Once free slide the drip edge out and discard.
If it doesn t pull the drip edge out slightly from under the shingles.
Apply a continuous bead of cement along the top of the drip edge then press down on the shingle.
Installing drip edge on your roof.
Tools supplies tin sn.
There was no way that the gutter installe was going to get the upper edge of the gutter behind the drip edge.
It is best to install a drip edge on a day with warm weather because it makes it easier for the shingles to be stripped back.
Ideally it is recommended to nail about every 12 inches.
You may need to nail through the starter strip into the drip edge.
Place a nail at one end then the other.
How to install drip edge flashing to a new roof.
While the vertical leg should be placed 1 4 1 2 away from the fascia.
Slip the wide flat flange of the material all the way under the first course of roof shingles as illustrated.
It can be done.
Make sure to support the long end of the cut if you let it fall after cutting it will bend down and kink the drip edge.
The roofer installed the drip edge tight against the fascia.
However keep in mind that tile shingles or materials like slate cannot be lifted so always install a gutter apron for new roofing.
Be sure to tuck the drip edge under the starter strip and felt paper.
Secure the drip edge with roofing cement.
This is important to protect damage to your fascia soffits rafters.
To install a drip edge on a newly constructed roof or on a re roofing job attach the drip edge along the roof s eaves first.
Begin at the lower corner of the roof and gradually progress to the top.
