Roofing Starter Strip Installation

Installation of the manufacturer s starter shingle is convenient and is the best product to use as the starter course.

Roofing starter strip installation.

The end should overhang over the edge about 1 4 to 3 4 of an inch. Speeds installation and helps improve safety. Roofing underlayment and drip edge have of course been applied first. The continuous sealant ensures an effective seal between the starter and the first course of shingles.

Use with any shingle that has an exposure of up to 6. Gaf mastering the roof chapter 09 this video demonstrates the proper installation technique for gaf starter strips. Perforated down the center for easy separation. Owens corning starter strip shingle helps save time by eliminating the need to cut shingles to create a starter row.

Gaf pro series starter strip shingles valley hip install. Continuing with the starter shingles. Before peeling the shingle starter strip trim about 4 inches off an end of the first starter strip and align the strip to the area you are planning to stick it on. Starter strip shingle eliminates the need to cut off tabs or headlap.

Install the starter strip which is just a backing for the first visible row of shingles. Notice where the nails are placed on these special starter strips. Starter strip shingle advantages. It is packaged two pieces per shingle 16 shingles per bundle.

Detailed installation of starter strip shingles at the valleys and hips. Quick installation tips for how to install gaf starter strip shingles on a roof. It s easy for a single person to position starter strip shingle on the roof. Butt the edges together instead of overlapping them.

Using four roofing nails or up to six in high wind areas secure the starter shingle to the surface of the roof. The half width full length starter strip is nailed with a 1 4 to 1 1 4 overhang past the drip edge or roof edge. It stops water from getting through to the roof at the gaps between shingles and at the notches between tabs. It s not complicated and you do not ne.

The nails are 1 1 2 to 3 above the bottom edge of the roof. You can save a few bucks using pre cut starter strips instead of using a whole shingle. Do not penetrate the shingles with the hammer.