Use water for a.
Tack cloth hardwood floor.
After laying down the first coat and sanding it you can choose to use a tack cloth to remove dust between subsequent coats.
Pressing lightly on the tack cloth will reduce the amount of stickiness left on the surface.
Using a soft bristle attachment thoroughly vacuum the floor baseboards and windowsills.
Carefully vacuum up dust and grit from the sanding process and then wipe down the floor with a tack cloth to pick up any remaining dust.
I like the terry cloth towel over a push broom method.
This will keep the.
Wipe surface clean with.
Dry tack your hardwood floors with a clean dry microfiber mop.
Pour the polyurethane into a paint bucket.
A tack cloth is simple to use.
Gently apply the polyurethane to the floor using a paintbrush.
Clean the surface of the floor.
Starting from the furthest point drag your mop.
This stickiness can translate to your wood floor.
You may initially use a tack cloth if you re re coating your hardwood floor rather than refinishing it from a raw state.
Take a shower or at least shake yourself off well before you continue.
Beeswax is not noxious or toxic but it can be annoying since your hands remain tacky for a day or two.
The larger the area you are working with the more difficult it gets to maintain that perfectly light pressure as you get tired and complacent.
How to use tack cloth.
Wiping down surfaces with tack cloth isn t difficult and it s a fast job.
After you have used a tack cloth your hand will be sticky.
Start in the middle and feather it out as you work toward the edges of the sanded floor.
A work surface with a 4 square foot area can be wiped down with tack cloth in less than a couple of minutes.
After you have done that final light polishing you can begin the cleaning process.
Ain t gonna happen no way no how.
Wet tack your wood floors with a microfiber mop using the same technique as mentioned above.
Clean the area with a tack cloth until it s completely dust free.
This may not apply to everyone but it is human nature to get tired of manually tacking with a tack cloth after several hundred square feet of it.
Fyi you will never get a 100 flawless finish on floors.
A tack cloth a rag soaked with either water or a solvent such as mineral spirits is used to wipe the floor before staining and applying polyurethane.
A sanding pole makes it easier on your knees but hand sanding allows you to spot embedded debris.
I ve used the bona microfiber mops and they re good but they seem to be a little more trouble and the dampened towel works just as well.
However it can look like a 110 job if you do it right.
